— 10 —
Cutter open tab
Cutter unit
Print head release lever
Paper chute
Paper roll location
Take-up spool
Printer
NOTE
The POS terminal UP-820N may be configured with multiple types of printers offered by the market. For
specific instructions related to the handling and care of the printer, please refer to the applicable printer
instruction manual.
The built-in printer is a 2-station (receipt/journal) type thermal
printer, and therefore it does not require any type of ink ribbon
or cartridge. The average life of the printer is approximately 5
million lines.
To open the printer cover, lift up the cover as shown in the
illustration on the right.
Your POS terminal is shipped with the print
head release lever held by a white retainer in
the lifted up position. Be sure to remove this
retainer and push down the print head release
lever before you use the terminal.
Print head release lever
The print head can be lifted by the green lever
on the right side of the printer. Pulling the lever
forward lifts the print head up. If the paper
becomes jammed, you need to lift the print
head.
Cutter open tab
If a paper jam occurs, pull the cutter unit open
while pushing the cutter open lever to the
right. Then remove the paper jam inside the
printer. For further information, refer to the
"Removing a paper jam" section in the "Opera-
tor Maintenance" chapter.
NOTE
Do not attempt to remove the paper roll with the head in the down position. This may result in damage to
the printer and print head.
Printer cover
