A SERVICE OF

logo

Open as PDF
next previous
Bobbin Winding
= Removing bobbin case
Remove the extension table from the machine by pulling itto
the leftoOpen the shuttle cover 0 by pulling down the
embossed part on the left ofthe cover,
Raise the needle to its highest position by rotating the
handwheel toward you_
(D Shuttle cover
_) Bobbin case
To remove the bobbin case (_) from the shuttle, pull open the
latch of the bobbin case. Pull the bobbin case straight out of
the shuttle.
• Bobbin winding
[] Release the clutch by pulling out the handwheel. This
will stop the needle from moving while you wind the
bobbin_
[]
[] Draw thread from spool°
[] Guide the thread around the thread guide.
[] Thread through the hole in the bobbin from the inside to
the outside.
[] Put the bobbin on the bobbin winder spindle,
[]
[]
[]
16