198
Appendix
TipsPlaybackConnections
Contents
Front panel Display Rear panel IndexRemote
Settings
Bass
Set subwoofer and LFE signal range playback.
2 Subwoofer Mode
Select low range signals to be reproduced by subwoofer.
LFE (Default) : The low range signal of the channel set to “Small”
speaker size is added to the LFE signal output from the
subwoofer.
LFE+Main : The low range signal of all channels is added to the LFE
signal output from the subwoofer. This is usually the best
setting for most systems.
%
•“Subwoofer Mode” can be set when “Speaker Config.” – “Subwoofer”
(vpage194) is set to other than “None”.
•Play music or a movie source and select the mode oering the strongest
bass.
•If “Front” and “Center” for “Speaker Config.” (vpage193) are set to
“Large”, and “Subwoofer Mode” is set to “LFE”, no sound may be output
from the subwoofers, depending on the input signal or selected sound mode.
Select “LFE+Main” if you want the bass signals to always be produced from
the subwoofer.
2 LPF for LFE
Set LFE signal playback range. Set this when you want to change the
playback frequency (low pass filter point) of the subwoofer.
80Hz / 90Hz / 100Hz / 110Hz / 120Hz (Default) / 150Hz / 200Hz / 250Hz
Impedance
Set the impedance of connected speakers.
8Ω/ohms (Default) : Select when the impedance per speaker for all the
connected speakers is 8 Ω/ohms or larger.
6Ω/ohms : Select when the impedance for any of the connected speakers
is between 6 Ω/ohms and 8 Ω/ohms.
%
•Check the speaker impedance (Ω/ohms) shown on the back of your speakers or in
the instruction manual beforehand.
Front Speaker
Set the front speaker A/B to use for every sound mode.
%
•This can be set when “Assign Mode” (vpage192) is set to “7.1ch + Front B”.
A (Default) : Front speaker A is used.
B : Front speaker B is used.
A+B : Both front speakers A and B are used.
%
•This can be set by pressing SPKR A/B on the main unit.
