197
Appendix
TipsPlaybackConnections
Contents
Front panel Display Rear panel IndexRemote
Settings
Crossovers
Set in accordance with the lower limit frequency of the base frequencies
that can be played back through each speaker.
2 Speaker Selection
Selects how to set the crossover frequency. See the speaker manual
for information concerning speaker crossover frequency.
All (Default) : Sets the same crossover frequency for all speakers.
Individual : Selects the crossover points for each speaker individually.
2 Set the crossover frequency
40Hz / 60Hz / 80Hz (Default) / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz /
200Hz / 250Hz
%
•“Crossovers” can be set when the “Subwoofer Mode” (vpage198)
setting is “LFE+Main”, or when you have a speaker that is set to “Small”.
•The default crossover frequency is “80Hz”, which will work best with the
widest variety of speakers. However, we recommend setting to a higher
frequency that the crossover frequency when small speakers are used. For
example, set to “250Hz” when the frequency range of the speakers is 250
Hz – 20 kHz.
•For speakers set to “Small”, low frequency content below the crossover
frequency is attenuated to the speakers and the low bass content is then
re-delivered to the subwoofer, or the front (L/R) speakers if they have been
set to Large.
•The speakers that can be set when “Individual” is selected dier depending
on to the “Subwoofer Mode” (vpage198) setting.
•When “LFE” is selected, speakers set to “Small” at “Speaker Config.”
(vpage193) can be set. If the speakers are set to “Large”, “Full Band” is
displayed and the setting cannot be made.
•When “LFE+Main” is selected, speakers can be set regardless of the
“Speaker Config.” (vpage193) setting.
