Network/Ports
37
Using the MFP menus
USB Buffer Configures the size of the USB input
buffer.
Note: Changing the USB Buffer
menu item automatically resets the
MFP. Any permanent resources,
such as fonts or macros, are lost.
Disabled Job buffering is disabled. Any jobs
already buffered on the hard disk are
printed before normal processing of
incoming jobs resumes.
Auto* The MFP automatically calculates the
USB Buffer size (recommended
setting).
3K to maximum size
allowed
(1K increments)
The user specifies the USB Buffer
size. The maximum size depends on
the amount of memory in the MFP, the
size of the other link buffers, and
whether Resource Save is set to On or
Off. To maximize the range for the
USB Buffer size, disable or reduce the
size of the parallel, serial, and network
buffers.
Job Buffering This menu item is shown only when
a formatted hard disk is installed.
Temporarily stores jobs on the MFP
hard disk before printing.
Note: Changing the Job Buffering
menu item automatically resets the
MFP. It is reset to configure memory,
and any permanent resources, such
as fonts or macros, are lost.
Off* Does not buffer print jobs to the hard
disk.
On Buffers print jobs to the hard disk.
Auto Buffers print jobs only if the MFP is
busy processing data from another
input port.
Mac Binary PS Configures the MFP to process
Macintosh binary PostScript print
jobs.
On The MFP filters PostScript print jobs
using standard protocol.
Off The MFP processes raw binary
PostScript print jobs from computers
using the Macintosh operating system.
Note: This setting often causes
Windows print jobs to fail.
Auto* The MFP processes print jobs from
computers using either Windows or
Macintosh operating systems.
ENA Address Sets the USB port ENA Address. 4 field IP address
(0.0.0.0*)
Shown only if an ENA is attached
through the USB port.
ENA Netmask Sets the USB port ENA Netmask.
ENA Gateway Sets the USB port ENA Gateway.
Menu item Purpose Values and descriptions
