w
When the button is pressed for the first time the
previous value is displayed on the top wine cooling
zone temperature display
Fig. 2 (8)
or on the bottom
wine cooling zone temperature display
Fig. 2 (7)
.
u
To change the temperature in 1 °F (1 °C) steps: Press
the button briefly.
-or-
u
To change the temperature continuously: Hold the
button down.
w
The new value flashes while the settings are being
made.
w
The actual temperature is displayed about 5 seconds
after the last button is pressed. The temperature slowly
adjusts to the new value.
5.8.3 Fan
If the fan is running the relative humidity in the interior
increases so that the corks do not dry out.
Energy consumption increases if the fan is switched on.
To save energy, the fan automatically switches off when
the door is open.
Switching the fan on
u
Press the ventilation
Fig. 2 (18)
button
briefly.
w
The Ventilation symbol LED lights up.
w
The fan continues to run. The humidity is high.
Switching the fan off
u
Press the ventilation
Fig. 2 (18)
button briefly.
w
The Ventilation symbol LED is dark.
w
The fan only works when this is necessary to control
the temperature. The humidity is low.
5.8.4 Dim mode
With models with glass doors you can set dim mode for
the light, i.e. the intensity of the light after the door has
been closed.
Setting dim mode
Note
u
If the dim mode is disabled the light slowly gets darker
and then goes out after the door has been closed.
u
Press the light
Fig. 2 (17)
button briefly.
w
The light button
Fig. 2 (17)
comes on. The dim mode is
selected.
The settings apply to all wine cooling compartments.
u
Setting the light brighter: Press the light button
Fig. 2 (17)
and the wine cooling zone UP button
Fig. 2 (14)
at the same time.
u
Setting the light darker: Press the light button
Fig. 2 (17)
and the wine cooling zone DOWN button
Fig. 2 (13)
at
the same time.
5.8.5 Description labels
You can write which wines are stored in the respective
compartments on the labels. You can obtain additional
description labels from your dealer.
Writing on the labels
5.8.6 Wooden shelf
Note
u
Do not load the wooden shelf with more than 26.46 lbs
(12 kg).
Ensure that the wooden shelf
does not remain suspended
on the rear hook.
u
To remove the folding
wooden shelf: lift upwards
out of the pull out rail and
pull it forwards.
u
To fit the folding wooden shelf: push it under the rear
hook and press onto the rails until it clicks into place.
u
To remove the lower
wooden shelf: pull forward
at an angle and lift up at the
same time.
u
To fit the lower wooden
shelf: insert over the stop
fitted to the undershelf until
it hits the back wall of the
appliance and press down.
u
To insert other wooden
shelves: attach to the rails.
6 Maintenance
6.1 Replacing the active carbon filter
The active carbon filter guarantees optimum air quality
and should therefore be replaced once a year. It can be
ordered from a dealer.
Each wine cooling compartment is fitted with an active
carbon filter.
Maintenance
12 * Depending on model and options
