EPSON FX-2180 Service Manual Chapter 4 Disassembly and Assembly
4-19
C B S screw s (3 x 6)
Figure 4-26. Removing the Right Frame Assembly
IMPORTANT
The tightening torque for the hexagonal nut is
1.18 - 1.37 Nm (12 - 14 Kgf-cm).
Adjust the platen gap/parallelism and
bidirectional print alignment, and reset the TPE
level. (See Chapter 5.)
4.2.11.6 Disassembling the Right Frame Assembly
1.
Remove the printer cover, front and rear edge guide assemblies, front
cover, paper eject assembly, and front and rear tractor units. (See
section 4.2.1.)
2.
Remove the panel board assembly. (See section 4.2.2.)
3.
Remove the upper housing assembly. (See section 4.2.7.)
4.
Remove the printer mechanism. (See section 4.2.11.)
5.
Remove the PF motor assembly. (See section 4.2.11.2.)
6.
Remove the right sub frame assembly. (See section 4.2.11.4.)
7.
Remove the right frame assembly. (See section 4.2.11.5.)
8.
Remove the following 11 parts from the right frame assembly:
2 compression springs (200 g) 2 plain washers
2 spur gears (34.5 mm) 1 spur gear (34 mm)
1 spur gear (27 mm) 1 spur gear (21 mm)
1 combination gear (8 mm, 31.5 mm) 1 intermittent gear
IMPORTANT
When assembling the right frame assembly,
attach the 11 parts listed in step 8 to the right
frame assembly as shown in the following
figures.
