Basic Configuration
3-11
Web – Click System, Bridge Extension.
CLI – Enter the following command.
Setting the Switch’s IP Address
An IP address may be used for management access to the switch over your
network. By default, the switch uses DHCP to assign IP settings to VLAN 1 on the
switch. If you wish to manually configure IP settings, you need to change the
switch’s user-specified defaults (IP address 0.0.0.0 and netmask 255.0.0.0) to
values that are compatible with your network. You may also need to establish a
default gateway between the switch and management stations that exist on another
network segment.
You can manually configure a specific IP address, or direct the device to obtain an
address from a BOOTP or DHCP server when it is powered on. Valid IP addresses
consist of four decimal numbers, 0 to 255, separated by periods. Anything outside
this format will not be accepted by the CLI program.
Console#show bridge-ext 4-146
Max support vlan numbers: 255
Max support vlan ID: 4093
Extended multicast filtering services: No
Static entry individual port: Yes
VLAN learning: IVL
Configurable PVID tagging: Yes
Local VLAN capable: Yes
Traffic classes: Enabled
GMRP: Disabled
Console#
