Filter
Top Products
iii
IMPORTANT SAFETY INSTRUCTIONS
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, EXPLOSION OR INJURY:
• Do not open the unit. There are no servicable parts inside.
• Do not operate in rain, snow or wet conditions.
• Do not use with high voltage or heat generating appliances.
• Do not use in locations that may accumulate flammable fumes and gases.
• Do not expose to extreme heat or flames.
• Do not replace fuse with one of a higher amperage rating.
• Do not block ventilation slots.
• Disconnect from vehicle when not in use.
WARNING
Inverter produces 120 volt AC current.
SAVE THESE INSTRUCTIONS
ii
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate
the equipment.
VEC401_Manual_030705 3/9/05 2:45 PM Page ii