Filter
Top Products
10
Precautions
Depending on the country, there are limitations on the use of certain
types of radio waves. In some cases, use of the system may lead to a
fine or other penalty.
If the PSP® system or UMD
®
is brought directly from a cold location
to a warm one, moisture may condense on the lens inside the system or
on the UMD
®
. Should this occur, the system may not operate properly.
In this case, remove the UMD
®
and turn off and unplug the system. Do
not put the UMD
®
back in until the moisture evaporates (this may take
several hours). If the system still does not operate properly, visit
http://www.us.playstation.com/support or contact SCEA Consumer
Services at 1-800-345-7669 for assistance.
• Do not touch the opening on the rear of the disc (recorded surface of
the disc) with your fingers.
• Do not allow dust, sand, foreign objects or other types of dirt to get
on the disc.
• If the UMD
®
becomes dirty, gently wipe the exterior and recorded
surfaces of the UMD
®
using a soft cloth. Do not use solvents or other
chemicals.
• Do not use a UMD® that is cracked or warped or has been repaired.
The UMD® may break inside the PSP® system, leading to injury or
malfunction.
Follow the guidelines listed below to help avoid deterioration or
discoloration of the PSP® system:
• Do not use solvents or other chemicals to clean the exterior surface.
• Do not allow the system to remain in direct contact with rubber or
vinyl products for an extended period of time.
• Do not use a chemically-treated cleaning cloth to wipe off the system.
• Do not attempt to remove the analog stick from the system front, as
doing so will damage the system and may result in injury.
• For best results, go to (Settings) (System Settings),
and then with the "System Information" screen displayed, rotate the
analog stick in a circular motion. This will adjust the analog stick's
range of movement.
For safety reasons, unplug the AC power cord from the electrical outlet,
disconnect any other cables and remove the battery pack from the
system before cleaning.
Cleaning the exterior surface and LCD screen
Wipe gently with a soft cloth.
Cleaning the connectors
If the headphones or remote control connectors become dirty, this
could cause noise or interruptions in sound. Wipe the connectors with
a dry, soft cloth to keep in clean condition.
Overseas use
Moisture condensation
UMD® handling
Handling and care of exterior surfaces
Before using the analog stick
Cleaning