Filter
Top Products
3-9 (E)
HDCU-950 IMM
* Slot-5 Diag *
Front: RC
Squeeze
PLD V1.00 Config Done
Mode Normal
Rear: DIF
Output-A SD SDI
Output-B SD SDI
2
1
3
5
4
6
* Slot-5 Diag *
Front: FC
IN :1080/59.94I
OUT :1080/59.94I
PLD V1.00 Config Done
Mode Normal
Sub-Ref:HD 23.97i
Rear: SDI
1
2
3
6
4
5
3-3. Character Display Function
Page 12-1
Slot-5 Diag Dispaly
Displays the details of self-diagnosis of the RC-91 board
when it is mounted in the fifth slot from the left on the
front side of the unit.
No. Contents
1 Displays the aspect ratio conversion mode during down-
conversion.
2 Displays the state of the PLD (IC301 and IC504 on the
RC-91 board) version and PLD. (Config Done/Config NG)
Config Done : PLD (IC301 and IC504 on the RC-91
board) started correctly.
Config NG : PLD (IC301 and IC504 on the RC-91
board) did not start correctly.
3 State of the operation mode on the RC-91 board (Normal/
Test)
4 Displays when the DIF-124 board is installed in the rear
correctly.
5 Displays the type of signal that is output from the SD SDI
OUT1 connector on the rear panel. (SD SDI/VBS)
*8
6 Displays the type of signal that is output from the SD SDI
OUT2 connector on the rear panel. (SD SDI/VBS/MONI
SDI)
*9
*8 : When the HKCU-951 is installed, set the switch with S103 on the EN-
145 board. When the HKCU-951 is not installed, the switch is fixed to
SD SDI.
For details, refer to Section 1-6-7. “Setting of Switches on Boards _ EN-
145 Board”.
*9 : When S10-1 on the RC-91 board and the HKCU-951 are installed, set
the switch with S104 on the EN-145 board.
For details, refer to Sections 1-6-6 and 1-6-7. “Setting of Switches on
Boards _ RC-91 Board and EN-145 Board”.
Page 12-2
Slot-5 Diag Dispaly
Displays the details of self-diagnosis of the FC-88 board
when it is mounted in the fifth slot from the left on the
front side of the unit.
No. Contents
1 State of the MAIN INPUT signal format of the frame
converter
2 State of the conversion format of the frame converter
MAIN OUTPUT signal
3 Displays the state of the PLD (IC301 on the FC-88 board)
version and PLD. (Config Done/Config NG)
Config Done : PLD (IC301 on the FC-88 board) started
correctly.
Config NG : PLD (IC301 on the FC-88 board) did not
start correctly.
4 State of the operation mode on the FC-88 board (Normal/
Test)
5 Displays the signal format of the reference signal that is
input to the FRAME REF IN connector (Sub-Ref) on the
rear panel (with HKCU-953).
6 Displays when the SDI-73 board is installed in the rear
correctly.