Filter
Top Products
Before You Begin
6. Using Headphones
Insert phone jack into
PHONES on the side of player
for listening.
7. Connecting the k@zoo
Player to your Computer
1. Lift the rubber cover on the player and
turn it away from the socket.
2. Insert the smaller end of the connection
cable into the socket tightly.
3. Insert the opposite end of the connect-
ing cable to the USB socket on the back of
the computer.
3
Note: Have a Blast- Just Not in Your
Eardrums. Make sure you turn down
the volume on the unit before you put
on headphones. Increase the volume
to the desired level
only after head-
phones are in
place.
PHONES
4
Before You Begin
Note: Refer to the Software
Instruction manual for procedures in
setting up USB drivers and
transferring files to the player.
1
2
3
4. Insert batteries into the
player
A. To insert batteries, lift open the
battery compartment door.
B. Insert 2 “AAA”(LR03) batteries with
polarities corresponding to indications
on the compartment. (Refer to “More
information” for battery precautions.)
C. Close the door to the battery
compartment
Note: Refer to the power level indicator
on display for battery level.
Replace with new batteries when the
indicator is empty.
5. Inserting a
MultiMediaCard (Optional)
The player has built-in flash memory. To
extend the playtime, you can use the
optional MultiMediaCard slot.
A. Insert a MultiMediaCard into the card
slot when the player is off as the
diagram shows:
B. To remove card, slide EJECT in the
direction of the arrow.
EJECT
Push the battery
compartment door
up to open
-
-
+
+
-
Pull the ribbon
underneath the
batteries to remove
them
EJECT
Caution: Do not remove
MultiMedia Card during playback or
when power is on. It may result in
damages to the unit and the card.
RD1060 IB-EN 1/4/02 6:18 PM Page 10