12. Do not use this product near water (for example, near a shower, bathtub, sink or
swimming pool).
13. Never insert objects of any kind, other than those specifically approved for that
use by Icuiti, into any connectors, ports, slits or other openings in the product.
14. Unplug the product from any external power source before cleaning and do not
use any aerosol or liquid cleaners.
15. Do not disassemble this product. If service work is required, contact Icuiti using
the Support contact information shown near the front of this manual.
16. Do not overload any wall outlets, extension cords of other power supply source
(such as a USB computer connection).
17. Avoid using, while connected to an external power source, during an electrical
storm. Use a surge protector to protect the product from possible damage.
18. Do not pull or yank on the cable, kink the cable or tie it in a sharp or tight knot. Do
not hang the product or allow it to be suspended by its cable. Cables damaged by
such actions are not covered by the product’s limited warranty.
19. Do not leave a static image displayed for a prolonged period of time. If a static
image is displayed continuously for a long period of time, that image may stick on
the display—a phenomenon known as “image stick”. This condition is not
permanent, but may require a considerable amount of operational display time to
dissipate, dependent upon the degree of image stick. 30 to 60 minutes of
continuous motion display will eliminate most image stick effects.
20. Do not drop, strike, or cause any portion of the product to be struck or shaken
aggressively. Such actions may damage the product and void your warranty.
21. Save these instructions.
Unplug the product from all external power sources immediately if:
The power cord or USB cord is damaged or frayed.
Liquid has been sprayed, splashed or poured on the product.
Any component of the product has been dropped or damaged.
The product exhibits any distinct change in performance.