Filter
Top Products
Wireless Controller User Manual
67
Figure 38: Managed AP status
MAC Address: The Ethernet address of the controller-managed AP.
IP Address: The network IP address of the managed AP.
Age: Time since last communication between the Controller and the AP.
Status The current managed state of the AP. The possible values are:
• Discovered: The AP is discovered and by the controller, but is not yet
authenticated.
• Authenticated: The AP has been validated and authenticated (if authentication
is enabled), but it is not configured.
• Managed: The AP profile configuration has been applied to the AP and it's
operating in managed mode.
Failed: The Controller lost contact with the AP, a failed entry will remain in the
managed AP database unless you remove it. Note that a managed AP will
temporarily show a failed status during a reset.
Profile: The AP profile configuration currently applied to the managed AP. The
profile is assigned to the AP in the valid AP database.
Radio Interface: Shows the wireless radio mode that each radio on the AP is
using.
This page includes the following buttons:
• Delete—Manually clear existing APs