Filter
Top Products
14
SysEx
Send Program: The Program to be sent via SysEx. The available options are the individual Program
numbers or ALL (all Programs). Press the VALUE DIAL to send the Program. "PROG: ___ SENT" will appear
to confirm the Program was sent successfully.
Utilities
Contrast: The LCD contrast. The available options are 0 to 99.
Save Globals
On this page, press the VALUE DIAL to store your global settings. After "Stored" flashes three times on the
LCD, the global settings are stored in MAX25's internal memory.
OS
Version: MAX25's current operating system information.
Boot ROM: MAX25's current ROM read-only memory information.
Run Mode: Determines MAX25's power state. When set to On, MAX25 will operate normally. When set to
LowPower, MAX25 enters Low-Power Mode. (If you enter Low-Power Mode when your DAW is open,
MAX25 will resume control of the DAW immediately after exiting Low-Power Mode.)
Program Change Mode
Use the VALUE DIAL to select which message is sent: Program Change or Program Bank.
Program Change
MIDI Channel: This setting determines over which MIDI channel data is sent. The available settings are
Common, USB A1-A16, and USB B1-B16.
Program Number: This determines the Program number that will be sent. The available range is 000 – 127.
Please refer to your external module's documentation for information on its available programs.
MIDI to DIN: Determines whether or not MIDI data is sent to the MIDI OUT (On) or not (Off). MIDI data will
be sent to MAX25's USB connection regardless of this setting. Since an external module will usually be
connected to MAX25's MIDI OUT, we recommend leaving this set to On.
Program Bank
MIDI Channel: This setting determines over which MIDI channel data is sent. The available settings are
Common, USB A1-A16, and USB B1-B16.
Program Number: This determines the Program number that will be sent. The available range is 000 – 127.
Please refer to your external module's documentation for information on its available programs.
Msb / Lsb: These determine the MSB (Most Significant Bit) and LSB (Least Significant Bit). The available
range is 000 – 127. Please refer to your external module's documentation for information on its available
programs.
MIDI to DIN: Determines whether or not MIDI data is sent to the MIDI OUT (On) or not (Off). MIDI data will
be sent to MAX25's USB connection regardless of this setting. Since an external module will usually be
connected to MAX25's MIDI OUT, we recommend leaving this set to On.