Filter
Top Products
General Information
12
A fault indicator (FLT) and remote inhibit (INH) circuit provides additional shutdown protection, should either the GP-IB
and/or controller fail.
The FLT circuit provides the user with a means of knowing the status of any unmasked fault register bit independently of
the SRQ function available through the GP-IB. You don’t have to rely on the controller to inform you of a fault within the
power supply.
The INH circuit (which is also independent of the GP-IB) controls the RI bit in the fault registers, and provides a way to
disable the supply remotely (i.e. a "panic button’’). This gives you a means to bypass the controller and/or GP-IB to disable
the supply.
Safety Considerations
This product is a Safety Class 1 instrument (provided with a protective earth terminal). The instrument and this manual
should be reviewed for safety markings and instructions before operation. Refer to the Safety Summary page at the
beginning of this manual for a summary of general safety information. Safety information for specific procedures is located
at appropriate places in this manual.
Options
Options are standard factory modifications or accessories that are delivered with the supply. The following options are
available. Note lower output power and voltage specifications for Option 100, which is described in Appendix A.
Option Description
001 Blank Front Panel for line Options 120, 220, and 240 Vdc
100 Input power: 100 Vac + 6%, -10%;
48-63 Hz single phase.
120 Input power: 120 Vac +6%, -13%.
48-63 Hz single phase.
220 Input Power: 220 Vac +6%, -13%;
48-63 Hz, single phase.
240 Input power: 240 Vac +6%, -13%;
48-63 Hz, single phase.
800 Rack mount kit for two units side by side
(Agilent 6033A and Agilent 6038A only)
W30 Extended Warranty
908 Rack mounting kit
909 Flanges with Handles
910 One additional Operating and Service Manual for each Option 910 ordered.
Accessories
The System-II cabinet accessories listed below may be ordered with the power supply or separately from your local Agilent
Technologies Sales and Support Office (see list of addresses at rear of this manual).
For 6030A, Agilent 603lA, Agilent 6032A, Agilent 6035A only
Agilent Part No
Description
5062-3989 Front handle kit for 5-1/4 inch high cabinets
1460-1345 Tilt stand (1) snaps into standard foot on; must be used in pairs
5062-3977 Rack flange kit for 5-1/4 inch high cabinet (will be shipped with supply if ordered as
Option 908)
5062-3983 Rack mount flange kit with handles