95 Z4Mplus and Z6Mplus User Guide
Routine Care and Adjustments
Cleaning Procedures
Fuse Replacement
A user-replaceable AC power fuse is located just below the AC power switch at the
rear of the printer. The replacement fuse is a 5 × 20 mm fast blow style rated at 5 Amp/
250 VAC.
Perform the following procedure to replace the fuse:
1. To replace the fuse, insert the tip of a flat blade screwdriver into the slot in the end
of the fuse holder end cap.
2. Press in slightly on the end cap and turn the screwdriver slightly counter
clockwise. This disengages the end cap from the fuse holder and permits removal
of the fuse.
3. To install a new fuse, remove the old fuse and insert the new fuse into the fuse
holder.
4. Push the end cap in slightly, then insert the tip of a flat blade screwdriver into the
slot in the end cap and turn clockwise to engage it.
Caution • Some commercially available lubricants will damage the finish and the
mechanical parts if used.
Caution • Before replacing the fuse, turn off the AC power switch and unplug the
AC power cord.
