tnstall properly...
Remove sales labels...
Check the strength of the floor It should hold the
weight of a ful!y loaded freezer
Pick a safe place, indoors, away from in-
flammables such as gasoline.
Allow 3 inches (7 5 cm] arr space on top of freezer
for proper ven+Uat~on
Allow at leas’ an inch (2 5 cm) between the
freezer conde.:ser. on ?he back of the unit, and
the wall
Allow “, inch [I 25 cm] on each srde of the freezer
for ease of rnstallatroc
If the freezer 1s to be agarnst a wall, you might
want to leave extra space on the hinge side so the
door can be ooened wrder
The four bolts ti-at held your freezer or the shrpping
crate are deslgned to be the levellrng legs Screw
the legs far enough Into the bolt holes, In each of
the four bottom corners, so the freezer stands
about 1 lrxh (2 5 cm] off the floor
Remove the Consumer Buy Guide label and any
inside labels before using the freezer.
To remove any remaining glue:
1 Rub briskly with thumb to make a ball, then
remove
OR
2 Soak area wrth drshwashrng detergent solutron (I
teaspoon detergent in 1 quart warm water] be-
fore removrng glue as described In step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE the Tech Sheet fas-
tened under the freezer at the front.
Clean it . . .
Clean your freezer before
using It See cleaning
rnstructrons on page 6
Plug it in...
Level freezer...
so the door wit stay
open at any postIon
Levelling Leg
Freezer
Power Cord
yluullulng plug
tower
Raise
Start adjustment with the door hinge side.
1. Slide freezer into place.
2. Adjust front legs to level the freezer.
- To raise front, turn each leg in the direction
shown.
- To lower front, turn each leg in the direction
shown.
3. Check with level.
4. After freezer is fully loaded, recheck with level.
4
3-prong grounding
type wall receptacle
Recommended Grounding Method
A 115 Volt, 60 Hz.. AC only 15 or 20 ampere fused
and properly grounded electrrcal supply IS re-
quired It IS recommended that a separate crrcurt
serving only thus applrance be provtded
Do not use an extension cord. Use a recep-
tacle which cannot be turned off with a switch
or pull chain. See indrvrdual electrical require-
ments and groundrng instruction sheet in your liter-
ature package