Pentair, Inc. VS-3050 Manual

A SERVICE OF

next previous

21

Drive Assembly Removal and Installation

ToremovetheIntelliFlo

®

driveandcontrolpanelfromthemotorassembly:

1. Makesureallelectricalbreakersandswitchesareturnedoffbeforeremovingthedrive.

2. Openthecontrolpanelcover.

3. RemovethethreePhillipsheadscrewssecuringthedrivetothemotorassemblyasshown.

 CAUTION: TO AVOID ELECTRICAL HAZARD, DO NOT REMOVE THE FOUR TAMPER

PROOF BITS FROM THE MOTOR ASSEMBLY

4. Liftupthedriveassemblyandremoveitfromthemotoradapterlocatedontopofthemotorassembly.

Note:Be careful not to remove the gasket between the drive and motor, it is critical in keeping

moisture out of the drive and motor. Replace the gasket if damaged. Do not reassemble with a

damaged or missing gasket.

ToinstalltheIntelliFlo

®

driveassemblyontothemotorassembly:

1. Makesureallelectricalbreakersandswitchesareturnedoffbeforeinstallingthedrive.

2. Besurethatthegasketbetweenthedriveandmotorisinplace.Itiscriticalinkeepingmoisture

outofthedriveandmotor.Replacethegasketifdamaged.Donotreassemblewithadamagedor

missinggasket.

3. Verifythatthethree(3)orangemotorpostcapsareinpositionbeforeplacingthedriveonthe

motorassembly.

4. Alignthedriveassemblywiththemotoradapterandseatthedriveonthemotorassembly.

5. SecureandtightenthedriveassemblywiththethreePhillipsheadscrews.

Phillips head screws

Phillips head screw

Do not remove

these screws

Adapter connector

Gasket

Orange motor post

caps (QTY. 3)

English