Bow Tonneau Cover
The tonneau cover is available on all walk-through open bow boats and is available as an
option on all other open bows. To install, begin at the bow of the boat attach snaps by
snapping cover to the deck of the boat. Work towards the windshield and walk-through.
Close the door on the windshield and attach snaps to the door, to remove simply reverse
procedure.
Notice:
The tonneau cover is not attached at the manufacturing facility
unless specified during boat order. If you would like tonneau
attached, please see your Malibu dealer.
Motorbox Cover
The upholstered motorbox reduces engine noise and
provides protection for the passengers on board. To open,
stand on the port side of the box near the observer seat,
grasp the handle near the floor and pull open. The motor
box is equipped with either one or two gas-filled shock
absorbers (depending on model) to provide support for the
compartment when opened.
Running the engine with the motor
box open exposes rotating
machinery which can cause injury
to occupants of the boat.
Driver’s Seat
The driver’s seat can be adjusted moving the seat forward and backward by pulling lever
located on front left side of the drivers seat. Pull lever outward, and adjust seat as needed.
The seat is also equipped with Air Lumbar Support. To adjust the lumbar support, locate
the knob on the rear left seat bottom. The lumbar support is an air bladder and will stay
constantly full unless the air is depressed from it. To decrease amount of air in bladder,
depress knob and lean back on seat until desired fullness is obtained. To fill bladder
again, simply lean forward while depressing button.
The V-Drive model driver’s seats are also equipped with adjustable swivel bases. To turn
seats, release the knob located directly below the front center of the seat by pulling
upward. Turn the knob on the lower seat base counterclockwise to loosen seat. Turn seat
to desired location and tighten seat by reversing these procedures.
Figure 2-15. Motorbox
2-12
®
