2-11
Before starting engine or engaging transmission, ensure all
swimmers are out of the water.
For more information regarding the safe operation and maintenance of the throttle control,
refer to the separate instructions located in the information packet shipped with your boat.
Steering System
It is important that you get the “feel” of your Malibu boat’s steering system. Turn the
wheel from full left to full right, and make sure the rudder is turning accordingly. The
system should operate freely and smoothly.
Notice:
It is normal for your Malibu steering to pull slightly to the right
under normal driving conditions. The boat will pull straight
while skier is under tow.
Power Trim
This switch is located forward of the throttle. It is used to activate the trim/tilt function on
the Flightcraft Outboard boats. Push and hold the switch until the engine is at the desired
angle. Use this switch to maximize boat performance in the water. The tilt raises the drive
for trailering.
Emergency Engine Stop Switch
The emergency engine stop switch attaches to the driver
of the boat and shuts down the engine if the driver of the
boat is accidentally forced away from the helm.
The switch consists of a helm-mounted switch plunger
and a switch clip/lanyard clip, which is connected
between the stop clip and the operator. Should the
operator move away from the controls, the clip pulls free,
releasing the plunger and stopping the engine.
If the engine must be shut down quickly, a pull on the
cord to release the clip from the switch will stop the
engine.
To reset the switch after activation, reinstall the switch clip.
Notice: If lanyard switch is damaged or lost you can purchase a new
switch through your local marina or Malibu dealer.
Figure 2-14. Stop Switch Lanyard
