21
Install memory, firmware, or option cards
Step 4: Install memory, firmware,
or option cards
If you do not have any memory, firmware,
or option cards to install, skip this step
and go to Step 5: “Load paper” on
page 31.
You can customize your printer memory
capacity and connectivity by adding
optional cards.
CAUTION: If you are installing memory or option cards
sometime after setting up the printer, turn the printer off
and unplug the power cord before continuing.
The instructions in this section help you
install any of the following:
• Memory cards
– Printer memory
• Firmware cards
– Additional functionality
– Internet capabilities
Note: You need a small Phillips screwdriver to remove
the system board access cover and to install some of the
cards.
– Flash memory
• Option cards
– Hard disk with adapter card
– MarkNet™ internal print
servers (also called internal
network adapters or INAs)
– Serial Interface Card
– Parallel 1284-B Interface Card
