A SERVICE OF

logo

12-14 FIN AL DRIVE
Output Bevel Gears
Output Drive Bevel Gear Removal
Remove:
Oil Pipe [A] (Engine Left and Outside, see Engine Lubri-
cation System chapter)
Output Drive Bevel Gear Cover Bolts [B]
Output Drive Bevel Gear Cover [C]
Remove:
Circlip [A]
Special Tool - Outside Circlip Pliers: 57001-144
Remove:
Output Drive Idle Gear [B]
Remove:
Output Drive Bevel Gear Housing Bolts [A]
Output Drive Bevel Gear Housing [B]
Output Drive Bevel Gear Installation
Install the output drive bevel gear housing.
Tighten:
Torque - Output Drive Bevel Gear Housing Bolts: 26 N·m
(2.7 kgf·m, 20 ft·lb)
Install the rotor [A] so that the projections [B] face out-
ward.
Tighten:
Torque - Rotor Mounting Bolts [C]: 12 N·m (1.2 kgf·m, 104
in·lb)
Install:
Output Drive Idle Gear
New Circlip
Special Tool - Outside Circlip Pliers: 57001-144