English-68
LUBRICATION
10. Hydraulic oil filter, change, PF 21
1. Remove the oil filter. If necessary, use a filter
remover.
2. Wipe new, clean engine oil onto the seal for the
new filter.
3. Fit the filter by hand with + 3/4 turn.
4. Remove the transmission cover and fill the
transmission’s oil tank, about 0.3 l oil.
See “13. Transmission oil level” on page 69.
Be observant when running the engine as
described below and fill so that the tank is not
emptied.
5. Run the engine warm, manipulate the equipment
lift and power steering, and then check that there
are no leaks around the oil filter seal.
6. Check the oil level in the transmission, top up if
necessary. The oil filter holds 0.3 litres of oil.
7. Replace the transmission cover.
11. Oil filter, change
1. Open the engine cover.
2. Drain the engine oil as described in “4. Engine oil”
on page 64.
3. Remove the oil filter. If necessary, use a filter
remover.
4. Wipe new, clean engine oil onto the seal for
the new filter.
5. Fit the filter by hand with + 3/4 turn.
6. Run the engine warm, then check that there are no
leaks around the oil filter seal.
7. Check the oil level in the engine, top up if
necessary. The oil filter holds 0.2 litres of oil.
IMPORTANT INFORMATION
Used engine or transmission oil is health-
impairing and must not be disposed of in the
ground or in nature.
Replaced filters must be handed in to the
workshop or other allotted placed for disposal.
Avoid skin contact; wash with soap and water in
case of spills.
8009-350
IMPORTANT INFORMATION
Used engine or transmission oil is health-
impairing and must not be disposed of in the
ground or in nature.
Replaced filters must be handed in to the
workshop or other allotted placed for disposal.
Avoid skin contact; wash with soap and water in
case of spills.
8009-161
