A SERVICE OF

logo

Open as PDF
next previous
16 Installing the Autoloader Chapter 1
Installing the Autoloader into a Rack
The autoloader fits all standard 19-inch racks, taking up 2U of space. To
install the autoloader into a rack, you will need to install the mounting brackets
on both sides of the autoloader and the rails in the selected rack location.
To install the autoloader, follow these steps:
1. Use a medium-sized standard screwdriver to remove the two screws near
the front on each side of the autoloader cover.
2. Using the screws you removed in step 1, secure one mounting bracket
(from the rackmount kit) to each side of the autoloader as shown below.
Figure 5 Installing Mounting Brackets (left side shown)