A SERVICE OF

logo

Open as PDF
next previous
2111
13
0198
321
7654
English
CLEANINGTHEHOSEANDNOZZLE
The vacuum cleaner stops automatically if the nozzle,
tube,hoseorfiltersands-bag®becomesblocked.Insuch
cases, disconnect from mains and allow to cool for 20-30
minutes.Clearblockageand/orreplacefiltersands-bag®
andrestart.
Tubes and hoses
1Useacleaningstriporsimilartoclearthetubesandhose.
2 It may also be possible to remove the obstruction in the
hosebysqueezingit.However,becarefulincasethe
obstruction is caused by glass or needles caught inside
thehose.
Note: The warranty does not cover any damage to the hose
caused by cleaning it.
Cleaning the floor nozzle
3 To avoid deterioration of suction power, frequently
cleanthecarpet/hardfloornozzle.Theeasiestwayto
cleanitisbyusingthehosehandle.
4 Presseachwheel-hubanddrawawaythewheels.
5 Removedust-balls,hairorotherobjectsthatmaybe
entangled.Usethecrevicenozzletocleanthewheel
axles.Replacethewheelsbypressingthemontothe
axles.
6 Largerobjectscanbeaccessedbyremovingthe
connection hose (press the small catches located on
each side and simultaneously draw the connection
tubeoutwardsinanuprightposition).
7 Removetheobject(s)andreplacetheconnection
hose.
Cleaning the power nozzle
(certain models only)
8 Disconnect from the mains, and remove entangled
threadsetc.bysnippingthemawaywithscissors.
9 Useascrewdrivertoremovethenozzlecover.
10 Remove the brush cylinder and bearings, then clean
asnecessary.
11 To clean the wheels, gently lever them from their
mountingsandcleanasnecessary.
12 Replace the cover and make sure it is securely
fastened.
Cleaning the turbo nozzle
(certain models only)
13 Disconnect the nozzle from the vacuum cleaner tube
andremoveentangledthreads,etc.bysnippingthem
awaywithscissors.Usethehosehandletocleanthe
nozzle.
12
2193277-01.indd 12 7/18/07 4:32:50 PM