120 Configuration: Disk Groups and Virtual Disks
snapshot virtual disk inherits the RAID controller module owner of its
associated source virtual disk. Changing the RAID controller module
ownership of a virtual disk changes the preferred RAID controller module
ownership of the virtual disk.
During a virtual disk copy, the same RAID controller module must own both
the source virtual disk and the target virtual disk. Sometimes both virtual
disks do not have the same preferred RAID controller module when the
virtual disk copy starts. Therefore, the ownership of the target virtual disk is
automatically transferred to the preferred RAID controller module of the
source virtual disk. When the virtual disk copy is completed or is stopped,
ownership of the target virtual disk is restored to its preferred RAID controller
module. If ownership of the source virtual disk is changed during the virtual
disk copy, ownership of the target virtual disk is also changed. Under certain
operating system environments, it might be necessary to reconfigure the
multi-path driver before an I/O path can be used.
To change the ownership of the virtual disk to the connected controller:
1
In the AMW, select the
Logical
tab and select a virtual disk.
2
Select
Virtual Disk
Change
Ownership/Preferred Path
.
3
Select the appropriate RAID controller module slot and click
Yes
to
confirm the selection.
Removing Host-to-Virtual Disk Mapping
To remove the host to virtual disk mapping:
1
In the AMW, select the
Mapping
tab.
2
Select a virtual disk from the
Defined Mappings
pane.
3
Perform one of these actions:
• Select
Mappings
Remove
.
• Right-click the virtual disk, and select
Remove Mapping
from the
pop-up menu.
4
Click
Yes
to remove the mapping.
book.book Page 120 Monday, June 21, 2010 11:00 AM
