Threshold Description
percentage of the controller’s total tunnel capacity that must be exceeded before the alert is
sent. The default threshold for this parameter is 80%
user-capacity
Set an alert threshold for the controller’s user capacity. The <percentage> parameter is the
percentage of the total resource capacity that must be exceeded before the alert is sent. The
default threshold for this parameter is 80%.
In the WebUI
1. Navigate to the Configuration > Management > Thresholdpage.
2. Modify the capacity percentages for any of the thresholds described in “Capacity Alert Thresholds” on page657.
3. ClickApply to save your settings.
In the CLI
4. To configure this feature, access the command-line interface in config mode and issue the following commands:
threshold
controlpath-cpu
<percentage>
controlpath-memory
<percentage>
datapath-cpu
<percentage>
no-of-locals
<percentage>
total-tunnel-capacity
<percentage>
user-capacity
<percentage>
Examples
The following command configures a new alert threshold for controlpath memory consumption:
(host) (config) #threshold datapath-cpu 90
If this threshold is exceeded then subsequently drops below the 90% threshold, the controller would send the
following two syslog error messages.
May 14 13:13:58 nanny[1393]: <399816> <ERRS> |nanny| Resource 'Control-Path Memory' has
gone above 90% threshold, value : 93
May 14 13:16:58 nanny[1393]: <399816> <ERRS> |nanny| Resource 'Control-Path Memory' has
come below 90% threshold, value : 87
DellPowerConnectW-SeriesArubaOS6.2 | User Guide Management Access | 663
