© Adam Equipment Company November 2011
7
3.5 WEIGHING
• Place the sample on the scale platform. The weight will be
displayed in the selected Unit.
• Wait until the stable indicator is displayed for accurate
weighing.
3.6 CHECK WEIGHING
Check-weighing is a procedure to sound an alarm when the weight of
the sample on the scale meets or exceeds the pre-set Low and High
values stored in the memory.
To set the High and Low values, follow the procedure given below-
•
Press the [High/Low] key. The display will show “000.00 HI”
with the first digit flashing for setting the High value. To set
your limit, use the [Unit] key to advance the flashing digit, the
[Tare] key to decrease the value of the flashing digit and the
[Zero] key to increase the value of the flashing digit .
• The display will now show “000.00 LOW” with the first digit
flashing for setting the Low value. To set your limit, use the
[Unit] key to advance the flashing digit, the [Tare] key to
decrease the value of the flashing digit and the [Zero] key to
increase the value of the flashing digit . Press [Mode] again
to confirm the value and the display will return to normal
weighing mode.
• Once the check weighing Limits are set and the alarm
function is active, a beep will sound slowly when the sample
weight is below the Low Limit. The beep will sound quickly if
the weight is above the High Limit. If the sample weight is in
between the Limits, the beep does not sound.
