© Adam Equipment Company November 2011
6
3.0 OPERATIONS
3.1 POWER
• Attach the mains adaptor to the power supply and plug the
connector into the socket on the Indicator The indicator will
charge the internal battery whenever it is connected to the
220VAC power supply.
• Push the ON/OFF switch at the back right hand side of the
indicator to the ON position to power up.
• Push the ON/OFF switch at the back right hand side of the
indicator to the OFF position to power down.
3.2 ZERO FUNCTION
• For accurate weighing, zero the display by pressing the key
[Zero] with nothing on the platform of the scale.
• The zero indicator 0 will be on.
3.3 TARE FUNCTION
• When the scale has a container on it press the [Tare] key.
• The Tare indicator Net will be shown.
• The display will show zero. If it does not show zero, press
the [Zero] key.
• To clear the tare, remove the container and press the [Tare]
key again. Press [Zero] to switch off the Tare indicator.
3.4 UNIT SELECTION
• The indicator can be set for different units by pressing the
[Unit] key. The options are kilogram, gram, pound and
ounce. They can be enabled as needed (see section 6.2).
Kilogram is always on.
