Access Control List Commands
44-6
44
ip access-group
This command binds a port to an IPv4 ACL. Use the no form to remove the port.
Syntax
[no] ip access-group acl_name in
• acl_name – Name of the ACL. (Maximum length: 16 characters)
• in – Indicates that this list applies to ingress packets.
Default Setting
None
Command Mode
Interface Configuration (Ethernet)
Command Usage
• A port can only be bound to one ACL.
• If a port is already bound to an ACL and you bind it to a different ACL, the
switch will replace the old binding with the new one.
Example
Related Commands
show ip access-list (44-5)
show ip access-group
This command shows the ports assigned to IPv4 ACLs.
Command Mode
Privileged Exec
Example
Related Commands
ip access-group (44-6)
Console(config)#int eth 1/2
Console(config-if)#ip access-group standard david in
Console(config-if)#
Console#show ip access-group
Interface ethernet 1/2
IP standard access-list david
Console#
