Filter
Top Products
5-46
Configuration
To access the LDAP Kerberos Set Up menu, access the command mode using a port
and password that permit access to Supervisor Level commands and then proceed as
follows:
• Text Interface: Type /N and press [Enter] to display the Network Parameters
Menu (Figure 5.9.) At the Network Parameters Menu, type 27 and press [Enter]
to display the LDAP Parameters menu (Figure 5.22.) At the LDAP Parameters
Menu, type 5 and press [Enter] and then use the resulting submenu to set the
Bind Type to Kerberos. Next, return to the LDAP Parameters menu. Note that the
LDAP Parameters Menu now includes a prompt which is used to select Kerberos
parameters. Type 14 and press [Enter] to display the Kerberos Set Up menu as
shown in Figure 5.32.
• Web Browser Interface: At the Home Screen, click on the Network Configuration
link to display the Network Configure menu (Figure 5.10,) and then click on the
LDAP Parameters link to display the LDAP Parameters menu (Figure 5.23.) At the
LDAP Parameters menu, click on the LDAP Kerberos Setup link to display the LDAP
Kerberos Setup menu as shown in Figure 5.33.
The LDAP Kerberos Setup menu allows you to define the following parameters:
• Port: (Default = 88.)
• Realm: (Default = Undefined.)
• Key Distribution Centers (KDC1 through KDC5): (Default = Undefined.)
• Domain Realms 1 through 5: (Default = Undefined.)