Filter
Top Products
14 ► RV06 User Manual
Weight ................................................................................................................................................... 2.6 lb/1.18 kg
Length................................................................................................................................................5 1/8 in/130 mm
Width .........................................................................................................................................................2 in/51 mm
Pressure ........................................................................................................................................10,000 psi/690 bar
Porting ..........................................................................................................................................1/4 in. Female NPT
HYDRAULIC SYSTEM REQUIREMENTS
The RV06 Rocker Valve hydraulic system requirements are determined by the hydraulic pressure rating of the tool
being controlled by the RV06. The following general rules apply when choosing a tool to match up with the RV06.
• Whenever possible, Stanley Hydraulic Tools recommends that you use the Stanley IP16 Intensapress intensi-
er to power the RV06 and tools attached to it.
• Make sure the compression tool, cutter, or lifting device attached to the rocker valve is capable of operation at
10,000 psi/690 bar.
• If the operating pressure of the compression tool, cutter, or lifting device attached to the rocker valve is below
10,000 psi/690 bar, DO NOT USE IT with an intensier or hydraulic supply adjusted to deliver 10,000 psi/690
bar.
• The intensier used to power the rocker valve can usually be adjusted for lower operating pressures. This work
should only be performed by a qualied hydraulic technician.
• If the intensier pressure cannot be lowered to match the tool you are using, you must either use a tool rated at
the available operating pressure or utilize an intensier with the correct output pressure.
• If you are in doubt about the tool or intensier you intend to use with the RV06, please contact Stanley Hydraulic
Tools for assistance.
SPECIFICATIONS