Filter
Top Products
RV06 User Manual ◄ 11
OPERATING PROCEDURES
• Observe all safety precautions given in this manual.
• Refer to the applicable manual for the tool connect-
ed to the RV06.
• Activate the parent circuit to provide power to the in-
tensier. Pressure will now be available at the pres-
sure port of the RV06.
• To advance the ram of the connected tool, press the
forward end of the rocker arm.
• When the crimp or cut is complete, release the rock-
er arm and the RV06 will go to a “neutral” or “hold”
position. The tool ram will remain stationary.
• To retract the tool ram, press the rear of the rocker
arm. If the RV06 is connected to a double-acting
tool, the ram will retract under power. If the tool is
single-acting, the ram will retract somewhat more
slowly due to its spring return.
COLD WEATHER OPERATION
If the RV06 is to be used during cold weather, preheat
the hydraulic uid at low engine speed. When using the
normally recommended uids, uid temperature should
be at or above 50 °F/10 °C (400 ssu/82 centistokes) be-
fore use.
Damage to the hydraulic system or RV06 can result
from use with uid that is too viscous or thick.
OPERATION