Filter
Top Products
9
Precautions
Before use
• Put both the PSP® system and the Remote Control in Hold Mode to
help prevent unintended operation.
Use the PSP
®
system and accessories according to the instructions in this
manual. No authorisation for the analysis or modification of the system,
or the analysis and use of its circuit configurations, is provided.
Disassembling will void the system warranty and may be harmful. The
LCD screen, in particular, contains dangerous, high-voltage parts, and
the laser beam for reading UMD may cause visual impairment if exposed
directly to the eyes.
When using the PSP® system's "Scan" function to select a wireless
LAN access point, access points that are not intended for public use
may be displayed. Only connect to a personal access point that you are
authorised to use, or one that is available through a public wireless
LAN or hotspot service.
When travelling note any applicable wireless regulations.
If the PSP® system or UMD is brought directly from a cold location to
a warm one, moisture may condense on the lens inside the system or on
the UMD. Should this occur, the system may not operate properly. In
this case, remove the UMD and turn off and unplug the system. Do not
put the UMD back in until the moisture evaporates (this may take
several hours). If the system still does not operate properly, contact the
appropriate PSP® customer service helpline which can be found within
every PSP® format software manual.
• Do not touch the opening on the rear of the disc (recorded surface of
the disc) with your fingers.
• Do not allow dust, sand, foreign objects or other types of dirt to get
on the disc.
• If the UMD becomes dirty, gently wipe the exterior and recorded
surfaces of the UMD using a soft cloth. Do not use solvents or other
chemicals.
• Do not use a UMD that is cracked or warped or has been repaired.
The UMD may break inside the PSP® system, leading to injury or
malfunction.
Follow the guidelines listed below to help avoid deterioration or
discolouration of the PSP® system:
• Do not use solvents or other chemicals to clean the exterior surface.
• Do not allow the system to remain in direct contact with rubber or
vinyl products for an extended period of time.
• Do not use a chemically-treated cleaning cloth to wipe off the
system.
Never disassemble the system or
accessories
Using the access point
Overseas use
Moisture condensation
UMD handling
Handling and care of exterior surfaces