Filter
Top Products
E-17
HT-SB500
2009 October 6 HT-SB500_A6_EN.fm
ENGLISH
Basic Operation
General control (continued)
Subwoofer level control
Note:
When sound from the speaker is distorted, decrease the
subwoofer level.
Center speaker level control
Bass control
Treble control
Touch Sensing off mode
Function
Note:
The backup function will protect the memorized function mode
for a few hours should there be a power failure or the AC power
lead becomes disconnected.
Auto power on function:
When you press the LINE 1-2 or DIGITAL 1-2 button on the
remote control, the speaker will turn on at last function.
Auto power off and auto detect signal:
If no analogue signal is detected within 1 minute or if “D1”/
“D2” display is blinking for 30 seconds during power on, the
speaker will automatically go to stand-by mode. The on/
stand-by indicator turns ORANGE.
The speaker will automatically power ON if it detects audio
signal from connected equipment.
Note:
Make sure to turn off any source/signal input to speaker before
going to stand-by mode because it will cause the speaker to
power ON again.
The speaker level can be adjusted.
To increase the level, press the
SUBWOOFER LEVEL button.
To decrease the level, press the
SUBWOOFER LEVEL button.
The center speaker level can be adjusted.
To increase the level, press the CENTER
SPK LEVEL button.
To decrease the level, press the CENTER
SPK LEVEL button.
1. Press the BASS/TREBLE button
to select “BASS”.
2. Within 5 seconds, press the
VOLUME (+ or –) button to adjust
the bass.
1. Press the BASS/TREBLE button
to select “TREBLE”.
2. Within 5 seconds, press the
VOLUME (+ or –) button to adjust
the treble.
During Stand-by mode, press the DIMMER/SENS ON/OFF
button on the remote control and the on/stand-by indicator will
turn from ORANGE to RED.
To turn the power on, press the ON/STAND-BY button on the
remote control or touch the ON/STAND-BY pad on the display
panel.
-5 -4 ... +4 +5
-5 -4 ... +4 +5
-5 +5
-5 +5
On the speaker:
When the FUNCTION pad on speaker
is touched, the input source will change.
Touch the FUNCTION pad on speaker
repeatedly to select desired input
source.
On remote control:
Press the LINE 1-2 button repeatedly to
select “L1” (LINE IN 1 input) or “L2”
(LINE IN 2 input).
Press the DIGITAL 1-2 button
repeatedly to select “D1” (DIGITAL IN 1
input) or “D2” (DIGITAL IN 2 input).
LINE 1
LINE 2
DIGITAL 1
DIGITAL 2