Filter
Top Products
DE (1)
FR (2)
ES (3)
SV (4)
IT (5)
NL (6)
PT (7)
ZH (8)
EN (9)
AR (10)
E-14
HT-SB500
2009 October 6
HT-SB500_A6_EN.fm
ENGLISH
Preparation for Use
Remote control
Battery installation
Precautions for battery use:
Remove the battery if the speaker will not be used for a long
period of time. This will prevent potential damage due to
battery leakage.
Caution:
Do not use rechargeable battery (nickel-cadmium battery, etc.).
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
Batteries (battery pack or batteries installed) shall not be
exposed to excessive heat such as sunshine, fire or the like.
Installing the battery incorrectly may cause the speaker to
malfunction.
Notes concerning use:
Replace the battery if the operating distance is reduced or if
the operation becomes erratic. Purchase “CR 2025”, coin
lithium battery.
Periodically clean the transmitter on the remote control and
the sensor on the speaker with a soft cloth.
Exposing the sensor on the speaker to strong light may
interfere with operation. Change the lighting or the direction
of the speaker if this occurs.
Keep the remote control away from moisture, heat, shock,
and vibrations.
Test of the remote control
Point the remote control directly at the remote sensor on the
speaker
.
The remote control can be used within the range shown
below:
Press the ON/STAND-BY button. Does the power turn on? Now,
you can enjoy your system.
1
Insert pin into the hole as shown and pull to open the
battery holder.
2
Remove the old battery from the battery holder, insert
the new battery and then slide the battery holder back
into the remote control.
Back of remote
control
Pin
Battery holder
Polarity (+) symbol
Battery type
Locking tab
Positive (+) side up
15°
15°
Remote sensor
0.2 m - 6 m
(8” - 20’)