Filter
Top Products
E-7
HT-SB500
2009 October 6 HT-SB500_A6_EN.fm
ENGLISH
Preparation for Use
Speaker preparation (continued)
Caution:
Be very careful to prevent the speaker [2.2 kg (4.84 lbs.)]
from falling when mounting on the wall.
Before mounting, check the wall strength. (Do not put on the
veneer plaster or whitewashed wall. The speaker may fall.) If
unsure, consult a qualified service technician.
Mounting screws are not supplied. Use appropriate ones.
Check all wall mount angle screws for looseness.
Select a good location. If not, accidents may occur or the
speaker may get damaged.
SHARP is not responsible for accidents resulting from
improper installation.
Driving screws
SHARP designed the speakers so you may hang them on the
wall. Use proper screws (not supplied). See below for size and
type.
Wall mount angle fixed to the wall
(Horizontal position)
(Continued to the next page)
To mount the speaker on the wall
3.2 mm (1/8")
9 mm (3/8")
Min. 22 mm (7/8")
5 mm
(3/16")
1 Fix the pattern paper to the wall in horizontal position
as below.
2 Make a hole on the wall following the screw point
marks on the pattern paper by using a drill.
3 Fix a wall mount plug into the hole using a hammer,
until it is flush with the wall surface.
29 mm
29 mm
44 mm
44 mm
509 mm
Pattern paper
Wall surface
Wall surface
8-9 mm (3/8")
32 mm (1-1/4")
Wall surface
8-9 mm (3/8")
32 mm (1-1/4")