Filter
Top Products
DE (1)
FR (2)
ES (3)
SV (4)
IT (5)
NL (6)
PT (7)
FI (8)
EN (9)
AR (10)
E-14
HT-SB400
2009 October 20
HT-SB400_A6_EN.fm
ENGLISH
Basic Operation
Subwoofer level control
Note:
When sound from the speaker is distorted, decrease the
subwoofer level.
Centre speaker level control
Bass control
Treble control
Touch Sensing Off mode
During Stand-by mode, press the DIMMER/SENS ON/OFF
button on the remote control and the on/stand-by indicator will
turn from ORANGE to RED.
To turn the power on, press the ON/STAND-BY button on the
remote control or touch the ON/STAND-BY pad on the display
panel.
Function
Note:
The backup function will protect the memorized function mode
for a few hours should there be a power failure or the AC power
lead becomes disconnected.
Auto power on function:
When you press the LINE button on the remote control, the
speaker will turn on at last function.
Auto power off and auto detect signal:
The speaker will automatically off after 1 minute of inactivity.
The ON/STAND-BY indicator turns orange. At this point, it will
automatically power ON if it detects audio signal from connected
equipment.
Note:
Make sure to turn off any source/signal input to speaker before
going to stand-by mode because it will cause the speaker to
power ON again.
The subwoofer level can be adjusted.
To increase the level, press the
SUBWOOFER LEVEL button.
To decrease the level, press the
SUBWOOFER LEVEL button.
The centre speaker level can be adjusted.
To increase the level, press the centre SPK
LEVEL button.
To decrease the level, press the centre SPK
LEVEL button.
1. Press the BASS/TREBLE button
to select “BASS”.
2. Within 5 seconds, press the
VOLUME (+ or –) button to adjust
the bass.
1. Press the BASS/TREBLE button
to select “TREBLE”.
2. Within 5 seconds, press the
VOLUME (+ or –) button to adjust
the treble.
-5 -4 ... +4 +5
-5 -4 ... +4 +5
-5 +5
-5 +5
When the FUNCTION pad on
speaker is touched or LINE 1 - 2
button on the remote control is
pressed, the input source will
change. Touch the FUNCTION pad
on speaker or LINE button on the
remote control repeatedly to select
desired input source.
LINE 1
LINE 2