Filter
Top Products
16 – COAXIAL REMOTE CONTROLLER
Connection & Control
TO CONTROL THE CAMERA USING RS-485 OUTPUT
AND CONTROL MENU KEYS
Connect the product to DC 12V power source or insert 4 AA-sized
batteries into the battery compartment.
(Power can be supplied via USB cable connection.)
Connect the RX(+/-) of the unit to the RS-485 (+/-) port of the camera.
Match the camera’s address, baud rate, and protocol to the same to
those of the unit.
-
For address switch, refer to the page 8.
Now you can control the camera by using the menus.
You can use the menu as following :
Press and hold [ENTER]: Moves to the main menu screen.
To exit the menu screen, press and hold the key again.
Press [ENTER] briefl y: Used to confi rm the current settings.
Four Direction Keys: Used to move the cursor up/down or left/right.
Control of pan/tilt/zoom using the buttons is not supported.
1.
2.
3.
3.
❖
–
–
–
–
RS-232 and RS-485 communications cannot be used simultaneously.
5-direction key (control menu) only supports A1 camera’s menu control.
NOTE
T
O
1
2
3
4
5
6
N
ADDRESS
(X)100 (X)10 (X)1
POWER
OFF ON
CABLE
COMPENSATION
SL
REMOTE CONTROLLER SCP-300
POWER STATUS
TERMINATION PROTOCOL
1
ON
23456781
ON
2