Filter
Top Products
English 13
Connection & Control
TO CONTROL THE CAMERA USING CONTROL MENU
KEYS AND COAXIAL / COAXITRON OUTPUT
Connect the product to DC 12V power source or insert 4 AA-sized
batteries into the battery compartment.
(Power can be supplied via USB cable connection.)
Connect the VIDEO IN of the unit and VIDEO OUT of the AI Camera directly.
The A1 camera and SPC-300 should be directly connected to the VIDEO IN.
Connect VIDEO OUT of the main unit to a monitor’s video input terminal.
You can control camera menu after setting the switch as shown below:
PROTOCOL
1
ON
23456784
PIN 4 Output Selection
ON COAXITRON
OFF
A1
COAXIAL
PROTOCOL
1
ON
23456787
PIN 7 Output Selection
ON COAXIAL OUT
OFF RS-485 OUT
Select the coaxial output by using the protocol switch pin 7.
The pin 7 coaxial / RS-485 has the output priority.
To select from COAXIAL or COAXITRON, use the pin 4.
You can use the menu as following :
Press and hold [ENTER]: Moves to the main menu screen.
Press [ENTER] briefl y: Used to confi rm the current settings.
Four Direction Keys: Used to move the cursor up/down or left/right.
1.
2.
–
3.
4.
–
–
❖
–
–
–
SCX-RD100
No address setting is required for connecting COAXIAL / COAXITRON camera and SCP-300.
If not in menu control, it operates ZOOM/FOCUS function for COAXIAL output. If not in
menu control, it operates PAN/TILT function for COAXITRON output.
For COAXIAL control, the camera should be set to SAMSUNG-E protocol.
When controlling COAXITRON menu while the menu is turned on, press and hold
ENTER key to exit the menu screen.
NOTE
ADDRESS
(X)100 (X)10 (X)1
POWER
OFF ON
CABLE
COMPENSATION
SL
REMOTE CONTROLLER SCP-300
POWER STATUS
TERMINATION PROTOCOL
1
ON
23456781
ON
2