Filter
Top Products
2. INSTALLATION MINI CONTROLLER
Installation of your Mini Controller is simple. Take the following steps:
1. You can choose one of the 16-letter-codes through the house code
screw wheel with the help of a small screw driver. Select the same letter
code as the ones on your modules and remote control (goes for RF
remote control and Philips Pronto).
2. Put the cable plug in a 230 VAC 50 Hz wall socket.
3. SET UP OF REMOTE CONTROL
To operate X–10 modules you have to set up the Home Automation IR code
on your X–10 remote control. This code can be found in the code book of
your remote control. (See the user’s manual of the remote control for
selecting a code for VCR, SAT etc.) Bear in mind that one of the modus
buttons of the remote control must be reserved for this Home Automation
code. For actual code lists of your Marmitek remote control, see
www.marmitek.com.
For others than X-10 remote control consult your user’s manual and the
code book of your remote control.
3.1 Operate via keyboard Mini Controller
1. Press the button corresponding to the Unicode of the module you want
to operate. Press ‘on’ to switch the module on; press ‘off’ to switch it
off. The choice switch decides which group of four unit codes will be
operated by the buttons of the keyboard ( 1-4 or 5-8 ).
2. To adjust ‘brightness’ press DIM/BRIGHT (this only functions when the
lamp is connected to a ‘lamp module’).
3. To switch on all lamps: press ‘all lights on’ button.
4. To switch off all modules: press ‘all units off’ button.
3.2 Operating with the help of your infrared (IR) remote control
To switch on/off a lamp or apparatus:
1. aim the remote control on the front of the Mini Controller.
2. press the mode button of your remote control reserved for Home
Automation.
3. select the number of the module via the numerical key board (1-9).
7IRRF7243
TM
ENGLISH