Filter
Top Products
Rev. 1.01 51 900.0570
8-Sept-05
APPENDIX C:
VCL (ORBITER/RAPIDDOME) DATA INPUT
The following Honeywell VCL (Orbiter/RapidDome) commands can be input into the
keyboard using an RS485 connection to the KBD port.
UP UP STOP
DOWN DOWN STOP
LEFT LEFT STOP
RIGHT RIGHT STOP
ZOOM IN ZOOM IN STOP
ZOOM OUT ZOOM OUT STOP
FOCUS NEAR FOCUS NEAR STOP
FOCUS FAR FOCUS FAR STOP
AUTO FOCUS ON AUTO FOCUS OFF
IRIS OPEN IRIS OPEN STOP
IRIS CLOSE IRIS CLOSE STOP
AUTO IRIS ON AUTO IRIS OFF
START RESUME TOUR OR AUTOPAN TOUR OFF
SEEK PRESET PROGRAM PRESET
WASH ON WASH OFF
WIPE ON WIPE OFF
LAMPS ON LAMPS OFF
AUX ON AUX OFF
NUMBERED AUX ON NUMBERED AUX OFF
CAMERA NUMBERED AUX ON CAMERA NUMBERED AUX OFF
TOGGLE MONO / COLOUR AUTOMATIC MONO / COLOUR
DEFINE TOUR START DEFINE TOUR STOP
DEFINE SECTOR RHS DEFINE SECTOR LHS
ALARM MODE ON ALARM MODE OFF
PRIVACY ZONE SETUP CAMERA SETUP
TOUR POINT DATA TURN 180 DEGREES
CAMERA AUTO ALARM SEEK TIME DEFINE HOME FUNCTION
REMOTE RESET SEEK ABSOLUTE POSITION
KD6_SEND_CHAR KD6_COMMAND
The following commands are ignored:
STATUS REQUEST
CAMERA ALARM STATUS REQUEST
ZONE STATUS REQUEST
ABSOLUTE POSITION REQUEST
ALARM STATUS REQUEST
GLOBAL COMMAND
PATROL
RELEASE RS485 BUS