Filter
Top Products
Related Manuals
2 3A2097B
Related Manuals
ProMix Manuals in English
Grounding
Ground all components in your system, as explained in
your ProMix Installation manual.
Ground a remote fluid regulator (used with Model
24H989 only) by connection to a properly grounded fluid
hose.
Installation (Model
249849)
The intrinsically safe flow control module (FC) is
required to use flow control in your system. See F
IG. 1.
1. Connect a 1/4 in. (6 mm) OD air supply line to the
air inlet fitting of the flow control module (FC). Con-
nect the other end of this line as follows:
a. Wall Mount Systems: Connect to the air mani-
fold at the rear of the wall mount fluid station.
b. RoboMix Systems: Install a 1/4 in. (6 mm) OD
tube tee at the air logic inlet of the RoboMix.
Connect the flow control air line to one branch
of the tee and the main air line to the other
branch.
2. Connect a fluid line from the proportioner to the 1/8
npt(f) fluid inlet of the flow control module (FC).
3. Connect a fluid line from the 1/8 npt(f) fluid outlet of
the flow control module (FC) to the spray gun inlet.
4. See the Electrical Schematic in your ProMix
instruction manual. Connect the flow control cable to
the fluid station control board and to the cable con-
nector on the flow control module (FC).
Manual Description
312778 ProMix 2KS Automatic System
Installation
312779 ProMix 2KS Automatic System
Operation
312780 ProMix 2KS Automatic System
Repair-Parts
3A1163 ProMix 1KS Installation
3A1080 ProMix 1KS Automatic System
Operation
3A1164 ProMix 1KS Repair-Parts
313881 ProMix 3KS Installation
313885 ProMix 3KS Automatic System
Operation
313883 ProMix 3KS Repair-Parts
Your system must be grounded. See the Grounding
instructions in your ProMix Installation manual.
FIG. 1. 249849 Flow Control Module
FC
Fluid to Flow Control Module
Air to Flow Control
Fluid to Gun
Flow Control Cable
TI13656a