Filter
Top Products
22D-Link DCS-940L User Manual
Section 4 - Conguration
Wireless
Select Enable to connect your camera to a wireless network.
Service Set Identier, an identier for your wireless network.
Select the Channel you would like to use.
Infrastructure is a wireless connection using an access point as a
transmission point of all wireless devices. Ad-Hoc is a wireless connection
used without an access point, where your DCS-940L is directly connecting
to your PC. This is done using the on-board wireless adapter on the DCS-
940L connected to a wireless adapter on the PC.
Allows the user to select the wireless protocol, 11g, 11b or auto detection.
For security, there are three choices; None, WEP, and WPA-PSK / WPA2-
PSK. Select the same encryption method that is being used by your
wireless device/ router.
A shared secret which was previously shared between the two sides
using some secure channel before it is used.
Wireless
Settings:
SSID:
Channel:
Connection
Mode:
Operation
Mode:
Wireless
Security Mode:
Pre-Shared
Key:
This section allows you to setup and congure the wireless settings on your camera.