Filter
Top Products
13D-Link DCS-940L User Manual
Section 2 - Installation
To create a WPS connection:
Step 1
Press and hold the WPS button for three seconds. The blue WPS status LED above the
button will blink.
Step 2
Press the WPS button on your router within 60 seconds. The WPS button is usually on the
front or side of your router. On some routers, you may need to log in to the web interface
and click on an on-screen button to activate the WPS feature. If you are not sure where the
WPS button is on your router, please refer to your router’s User Manual.
The DCS-940L will automatically create a wireless connection to your router. While
connecting, the green LED will ash and your camera will reboot.
WPS - Push Button Setup
WPS Button
Alternatively, you may automatically connect to your WPS-enabled wireless router or access point using the WPS Button on the back of the camera.