Filter
Top Products
WARRANTY / REPAIR
TWO-YEAR LIMITED WARRANTY
Your Bushnell® product is warranted to be free of defects in materials and workmanship for two years after the date of purchase. In
the event of a defect under this warranty, we will, at our option, repair or replace the product, provided that you return the product
postage prepaid. This warranty does not cover damages caused by misuse, improper handling, installation, or maintenance provided by
someone other than a Bushnell Authorized Service Department.
Any return made under this warranty must be accompanied by the items listed below:
1) A check/money order in the amount of $15.00 (USD) to cover the cost of postage and handling
2) Name and address for product return
3) An explanation of the defect
4) Proof of Date Purchased
5) Product should be well packed in a sturdy outside shipping carton, to prevent damage in transit, with return postage prepaid to
the address listed below:
IN U.S.A. Send To: IN CANADA Send To:
Bushnell Performance Optics Bushnell Performance Optics
Attn.: Repairs Attn.: Repairs
8500 Marshall Drive 25A East Pearce Street, Unit 1
Lenexa, Kansas 66214 Richmond Hill, Ontario L4B 2M9
For products purchased outside the United States or Canada please contact your local dealer for applicable warranty information. In
Europe you may also contact Bushnell at: BUSHNELL Performance Optics
Gmbh European Service Centre
MORSESTRASSE 4
D- 50769 KÖLN
GERMANY
Tél: +49 (0) 221 709 939 3
Fax: +49 (0) 221 709 939 8
This warranty gives you specific legal rights. You may have other rights which vary from country to country.
© 2005 Bushnell Performance Optics
10
11
MAINTENANCE AND CARE
1. The holographic image glass is coated with anti-reflection material. When cleaning the glass surfaces,
first remove any dirt and dust with compressed air or by blowing on the glass surfaces. Fingerprints or
lubricants can be wiped off with lens tissue or a soft cotton cloth, moistened with lens cleaning fluid
or glass cleaner. Never clean the glass surface with a dry cloth or paper towel; always dampen the glass
surfaces prior to cleaning.
2. All mo
ving parts of the sight are permanently lubricated. Do not try to lubricate them.
3. No maintenance is needed on the sight’s surface, except to occasionally wipe off with a soft cloth. Use
only a water-based cleaner such as glass cleaner, ammonia, or soap and water. Never use any solvent-
type cleaner such as alcohol or acetone.
4.
Never disassemble the sight. The optical cavity is nitrogen filled and sealed. Disassembly will void the warranty.
LASER SAFETY
The Bushnell® Holosight® XLP is a Class II laser product. The laser’s illuminating beam, however, is
contained within the housing. The only laser light accessible to the eye is at a power level within the limit
of a Class IIa laser product. The laser’s illuminating beam can become accessible to the eye if the housing
is broken. Turn the sight off immediately and discontinue use until repaired.