Front Panel Controls
Front Panel LCD
23063L-001 Rev. 2 6/21/2004 RXiIIIPlus User Guide 49
INIT FLASH
MEM
Initialize Flash Memory
Caution • Perform this operation only when it is necessary to erase all previously
stored information from Flash memory.
1. When the LCD displays
INITIALIZE CARD
, press the right oval to select
YES
.
(If you are prompted for a password, enter your password using the instructions in
Password-Protected Parameters on page 43.)
The LCD asks
INITIALIZE FLASH
.
2. Press the right oval to select
YES
.
The LCD asks
ARE YOU SURE?
.
3. Do you wish to continue?
• Press the left oval to select
NO
to cancel the request and return to the
INIT FLASH
MEM
prompt.
• Press the right oval to select
YES
and begin initialization.
When formatting is complete,
INIT FLASH MEM
displays.
SENSOR
PROFILE
Sensor Profile
The media sensor profile may be used to troubleshoot registration problems that may be
caused when the media sensor detects preprinted areas on the media or experiences
difficulty in determining web location.
• Press the right oval to start this standard calibration procedure and print a media sensor
profile.
Figure 29 shows a media sensor profile. If the sensitivity of the media and/or ribbon
sensors must be adjusted, use Calibrate Media and Ribbon Sensors on page 50 to adjust
the media and ribbon sensor sensitivity.
Figure 29 • Media Sensor Profile
Table 5 • Printer Parameters (Sheet 6 of 15)
Parameter Action/Explanation
