975-0082-01-01 69
Troubleshooting
Under certain conditions, the AGS generates a fault or warning message.
These messages appear on the Xanbus System Control Panel (SCP).
Acknowledging messages When a fault or warning message appears, it
will remain on the screen until it is acknowledged by pressing Enter on the
Xanbus System Control Panel (SCP). This action removes the message
from the screen, but does not clear the condition that caused the fault or
warning.
Consult Table 6 and Table 7 for recommendations for resolving the fault
after it has been acknowledged.
Warnings that are in the form of a Yes/No question can be acknowledged by
pressing Enter for Yes and Exit for No.
Self-clearing warnings If unacknowledged, some warnings may clear
themselves if the condition that generated the message goes away. For
example, if the AGS fails to start the generator, warning message W202
appears. However, if the generator starts on the next start try, the message
goes away.
Clearing faults To clear active AGS faults, highlight Clear Faults on the
AGS menu and press Enter.
Multiple faults and warnings If several fault or warning messages occur
before they can be acknowledged or cleared, they are displayed together on
a fault list or a warning list. These lists contain messages from every
Xanbus-enabled device, not just the AGS. Message details can be selected
and viewed from the fault list or warning list.
To view a message from a fault list or warning list:
1. On the list, use the arrow buttons to highlight the message to be
viewed.
2. Press Enter.
The complete message appears.
To return to the fault list or warning list, press Exit.
To continue to the menu for the device that caused the fault or warning
condition by pressing Exit.
Each time you return to the list after viewing a complete message, the
viewed message is removed from the list.
If you have left the fault list or warning list, you can view them at any time
from the System Settings menu.
To view a fault list or warning list:
1. On the Select Device menu, highlight System and press Enter.
2. On the System Settings menu, highlight View Fault List or View
Warning List.
3. Press Enter.
