Customizing
Page 27
ADJUSTING PITCH AND PHASE (VGA ONLY)
Some computers and video cards may not allow the auto-sync function to fully work when the
DTU-1931 is first connected. If some portion of text appears blurred, use the A
UTO ADJUST option to
automatically synchronize to the incoming signal (see the description about auto-sync on page 24).
If the image is still blurred, adjust pitch and phase by following the procedure below. For optimum
display quality, set your video card to the DTU-1931’s native resolution of 1280 x 1024.
POWER SAVING
The DTU-1931 conforms to VESA and ENERGY STAR
®
power saving guidelines.
When using the DTU-1931 with a Display Power Management Signaling (DPMS) compliant
computer or video card, the display will automatically comply with the below power saving
parameters.
When these power-saving functions are in effect, the screen display is darker than usual.
* Depending on the specifications and settings of your computer and video card, the power light may only
change to orange when in standby and suspend modes.
Computer mode H-sync V-sync Video Power consumption Power lamp
Power ON Yes Yes Active 37W, max. Blue
Standby mode No Yes Blanked 2W, max. Blue/Orange*
Suspend mode Yes No Blanked 2W, max. Blue/Orange*
OFF mode No No Blanked 1W, max. Orange
• In the Wacom Tablet control panel, select the
C
ALIBRATE tab.
• If you are working with multiple displays,
be sure the display corresponding to the
DTU-1931 is selected in the MONITOR menu.
• Click on the C
ALIBRATE... button to activate the
calibration screen.
• Using the OSD controls, open the OSD menu
and select the PITCH option. Then adjust the
pitch level so that the pattern of fine vertical
stripes displays evenly. (For details on
changing the OSD settings, see On Screen
Display (OSD) settings on page 24.)
• In the OSD menu, select the P
HASE option.
Adjust the phase level so that the adjustment
pattern shows clearly.
• After completing these adjustments, press the
E
NTER and MENU buttons to exit the OSD
menu.
• Click on the C
ANCEL button or press ESC to
exit the calibration screen.
Adjustment pattern for pitch and phase.
DTU193_Manual.fm Page 27 Monday, September 15, 2008 2:42 PM
